Initialize The Throttle For Processing

- Mar 18, 2019-

The first is to open the key to the second block, that is, the meter indicates the full light of the block, and then wait 20 seconds, step on the throttle to the end, keep about 10 seconds later, loosen the throttle, turn off the ignition switch, pull out the key, the initialization is done. The second is to open the key second block, hold for 30 seconds, then turn off the ignition switch and unplug the key.

It is important to note that after the two methods are done, we have to wait for a period of time before you can try to fire, generally wait 15-20 seconds, and then fire to see if refueling is normal, engine fault lights are off, if not successful, do a second time, until successful, generally can be a success, up to two times.

But according to the car's different, the method of reduction is not the same, some cars must be through the computer to complete the initialization, if it is the case, it is recommended that the owner of the car will be sent to the shop with professional equipment to clean.